ACRYLIC & GLASS TUMBLERS - CARE INFO

YOUR CUP IS ONE OF A KIND, LIKE YOU. TREAT IT GOOD AND IT WILL LAST YOU A LONG TIME.

(LIDS NOT FITTING CORRECTLY? CHECK THE RUBBER GASKET, MAKE SURE ITS LAYING FLAT AND LINED UP. GIVE THE LID A TURN, IT SHOULD FIT SNUG AFTER THAT.)

- LEAVING THEM IN THE A HOT CAR IS NOT SUGGESTED, EITHER IS THE FRIDGE OR FREEZER.

- NO SPA DAYS FOR THESE BABIES PLEASE! SOAKING IS A NO GO.

- ABRASIVE MATERIALS WILL SCRATCH THEM UP, AND UNLESS YOU LIKE THE ROUGH AND TUMBLE LOOK (WE ALL KNOW YOU HAVE A 'TYPE', WE'VE SEEN THE PICTURE OF YOUR EX), I WOULD SUGGEST USING THE SOFTER SIDE OF THE SPONGE.

- DROPPING OR THROWING THEM, WILL CAUSE THEM TO CRACK OR EVEN BREAK (JUST LIKE YOUR CRAZY EX). THERE'S NO FIXING IT IF IT DOES HAPPEN.

- IT SHOULD GO WITHOUT SAYING, BUT JUST IN CASE, THE MICROWAVE IS OFF LIMITS.

- IT IS POSSIBLE FOR THESE CUPS TO "SWEAT". DON'T WORRY IT HAPPENS TO ALL OF US. SO DON'T BE ALARMED IF YOU SEE CONDENSATION BUILD UP ON THE OUTSIDE, IT WON'T HURT THEM.

**FOR GLITTER GLOBE/LAVA LAMP STYLE TUMBLERS:

- THE MAGIC INSIDE DOES SETTLE OVER TIME, SO SHAKE IT UP TO ACTIVATE IT.

- JUST A HEADS UP: COLD LIQUIDS CAN SLOW THE FLOW.

** VINYL AND UVDTF DESIGN ELEMENTS:

- EVEN THOUGH I USE "PERMANENT" VINYL, IF PUT UNDER EXTREME TEMPS, IT COULD PEEL. I HAVEN'T HAD ANY CUSTOMERS COME BACK SAYING IT'S HAPPENED TO THEIRS BUT I DO HAVE TO GIVE FAIR WARNING.

- UVDTF DESIGNS: THESE FEEL "PUFFY" WHEN YOU RUN YOUR FINGER OVER THEM. I DID NOT CREATE THESE, THESE WERE CREATED BY OTHER ARTISTS AND PURCHASED. I CAN NOT GUARANTEE THEIR LONGEVITY DUE TO THE SIMPLE FACT THAT I, MYSELF, AM FAIRLY NEW TO THEM.